Author Topic: Truss Rod Cover (Read 659 times)

alembickoa · « **on:** August 16, 2012, 09:04:42 PM »

I would love to get a brass truss rod cover for the Orion and have it engraved with something specific. Should I go to our local dealer and place the order there or is it ok to radio the Mothership directly to place the order? Any advice is welcome.

Blessings...Steve

jacko · « **Reply #1 on:** August 17, 2012, 04:08:19 AM »

I asked Mica the same question a few years ago when I wanted a brass truss rod cover for my epic. I've lost the email reply but I do recall I would have to have sent the plastic one back so that they got the holes drilled I the correct place. I can't remember the cost but I guess it was more than I could afford at the time as I didn't proceed.

Graeme

David Houck · « **Reply #2 on:** August 17, 2012, 09:47:38 AM »

Like Graeme, my recollection too is that it is not as straightforward as you might think. So yes, contact the shop.

mica · « **Reply #3 on:** August 17, 2012, 04:14:14 PM »

It's not simple, but if you were coming by, and we knew in advance, we could fabricate one for you in a couple of hours. Engraving can't be done that quickly, but you could take it to any trophy shop or mall for the engraving.

alembickoa · « **Reply #4 on:** August 17, 2012, 10:23:45 PM »

Thank you, Mica...I am having an urge to venture north of the big orange bridge and possible end up in Alembicville. I will let you know, for sure.