Author Topic: 1982 Distillate - No LED, no Output, new 9v Battery (Read 130 times)

rickbass · « **on:** September 11, 2012, 01:55:45 PM »

I've owned my distillate for almost two years with no trouble... until last night. I plugged in and got no signal coming from the bass, and noticed that the LED light was out. I changed the battery and still, no LED and no sound. Any suggestions about how to proceed?

pauldo · « **Reply #1 on:** September 11, 2012, 02:40:59 PM »

Verify voltage of the 'new' battery.
Look for any loose connections.
??

keith_h · « **Reply #2 on:** September 11, 2012, 03:48:31 PM »

Check/clean the contacts on the 1/4 jack. The battery is switched through the jack.

Keith

rickbass · « **Reply #3 on:** September 11, 2012, 06:11:42 PM »

Thanks all, but to no avail. New battery is fine, cords are fine, no obvious loose connections within the electronics cavity and the 1/4 inch jack is clean.

Any recommendations for an Alembic Repair shop in central NJ?

flpete1uw · « **Reply #4 on:** September 11, 2012, 06:31:45 PM »

For what ever its worth I recently had the 1/4 jack break on me!! On my Distillate. One of the leafs in the jack broke off resulting in no signal path. No comment as far as the LED because I had it disconnected. The jack acts as a voltage switch for the battery as well as the signal.

Best of Luck
Pete

FC Bass · « **Reply #5 on:** September 11, 2012, 08:35:53 PM »

Make sure non of the metal parts (output and prints) is touching the paint in the cavity (which is conductive)