Wiring for three way Q switch

[dslapster64]

Does anyone have any information on the correct wiring for a three-way Q switch to replace a two wayQ switch?

[rv_bass]

This thread used to have a pdf of the instructions, they may have been lost with the recent website migration.  If you call Alembic they can provide you with an instruction sheet.

https://club.alembicguitars.com/index.php?topic=2218

[dslapster64]

Thank you , I’ll give them a call today.

[rv_bass]

I found an instruction sheet I had, here is a photo…

[dslapster64]

Oh my goodness, thank you so much. Blessing to you and all of yours

[dslapster64]

I'm sure there's been some changes since 1997, but something is better than nothing at all. This will certainly give me a start.

[JimmyJ]

I'm not sure that's exactly what you're looking for.  Aren't you asking about making the boost switch (essentially a 2-way) on your SC Signature into a 3-way?  As in, you want more boost?  I'm not sure I've seen instructions for that but somebody in here will know if that's doable. 

Jimmy J

[jazzyvee]

That 2 to 3 way is doable, I had it done on my signature basses some years back. If i remember properly, it came from alembic as pre wired switches and maybe some other bits that i had to swap with the originals and do a bit of soldering.

[dslapster64]

Hey fellas
The swap is for my Spoiler 5 . The switch came by itself with wires connected 👌, but with no installation instructions. The original switch is a 2 way.