« previous next »
Pages: [1]

Author Topic: Wire to board modular connector for the blend  (Read 181 times)

DaMitz

  • Junior Member
  • **
  • Posts: 13
    • mr.bones
Wire to board modular connector for the blend
« on: October 18, 2020, 04:30:48 AM »
On my Essence, some previous owner soldered the cables from the pickups directly on the blend. From factory they all have modular connectors, as seen on the picture. Where can I buy these connectors to rebuild my bass as it was coming from the factory. I searched the www with "mxn-14" but couldn`t get any results.
Cheers, Thomas
« Last Edit: October 19, 2020, 03:10:04 AM by DaMitz »
Logged

mica

  • alembic
  • Senior Member
  • *
  • Posts: 10595
Re: Wire to board modular connector for the blend
« Reply #1 on: October 19, 2020, 03:08:06 PM »
It looks like both male and female components are there, just the male ones are off the board. If you need something to repair an Alembic, just send me an email to   mica at alembic dot com
Logged

DaMitz

  • Junior Member
  • **
  • Posts: 13
    • mr.bones
Re: Wire to board modular connector for the blend
« Reply #2 on: October 20, 2020, 02:51:47 AM »
Thanx, just sent you an email.
Thomas
Logged

mica

  • alembic
  • Senior Member
  • *
  • Posts: 10595
Re: Wire to board modular connector for the blend
« Reply #3 on: October 20, 2020, 03:43:57 PM »
Sorry Thomas - I don't see an email, can you try again?
Logged
Pages: [1]
« previous next »