I'm embarrassed to admit (re Further "bright" mode)

[jerico]

I've had my Further since 2006, and I've always thought the "bright" pickup setting was painfully trebly, and never used that mode. It only dawned on me yesterday to set the bright mode to my "normal" listening preference, and then allow the "normal" mode to be a slightly rolled off variant of that.


Seriously, what was I thinking all this time?! When we talk about controls that need to be explored, we're not kidding!

[David Houck]

   

[lbpesq]

Justin, do you mean adjusting tone with the filter while in”bright” mode, or are you referring to internal trim pots of which I am unaware?

Bill, tgo

[jerico]

Hi Bill,


Simply just adjusting the tone knob while in bright, to a value a tad brighter than I'd normally want. That's it!


Facepalm...

[lbpesq]

I never thought of that!  Good idea!  I do use the bright setting, but very occasionally.  I much prefer the Q switch on my other Alembic equipped guitars.   I’ll have to give your idea a try.

Bill, tgo

[jerico]

Ironically, or perhaps unsurprisingly, a few weeks ago I started playing with the "preset depth" control on my Mesa amp, which I had also never used before (it basically controls the extremity of a V-shaped EQ curve - though I rarely even use the banded EQ on the amp). Normally I'd say I need to get out of the house more, but it seems that being stuck in here has me actually learning how to use my gear.


This is a great time to RTFM I guess (read the f***ing manual)!

[edwardofhuncote]

This thread was exactly the answer I needed. I've been trying to figure out these [off-on-bright] switches on my guitar... the bright setting was just too much from where I ordinarily would set the filters. They just don't have the same effect as a Q-switch does, and my brain was telling me it should... this actually is more usable for other things.


Now, if I could just play the thing... 

[mica]

Note that the brightness is adjustable with a trimpot on each of the switches inside the control cavity.

[lbpesq]

Wow, I’ve had my Further for 15 years and never knew that!  Thanks, Mica.

Bill, tgo

[jerico]

I missed the last few replies here - sorry, I am lagging behind the class a bit!

But yeah, wow, I didn't realize that either.


@Mica do you mean there's a separate internal trim pot for bright like in addition to the gain trimpot? I will need to open mine up and poke around a bit.


EDIT: I just opened my Further up, I do see the trimpots on the selectors (though I'm not sure I can easily access the one for the neck - it is sort of under the circuit board and the tube holding the pickup wires). I can't believe I never noticed that before though.

[paulman]

My filters were almost always open and I rarely used them since 2004 when I got the Further.  Been playing some other guitars for a while and started messing the tone controls watching Trey and others.

Getting back into this guitar I've been using the bright switches more in conjunction with filters, and it's brilliant (in sound and concept)!

Glad to hear and read others are doing the same

[mica]

@Mica do you mean there's a separate internal trim pot for bright like in addition to the gain trimpot? I will need to open mine up and poke around a bit.

EDIT: I just opened my Further up, I do see the trimpots on the selectors (though I'm not sure I can easily access the one for the neck - it is sort of under the circuit board and the tube holding the pickup wires). I can't believe I never noticed that before though.

Yes - you found them! We set them near the middle usually. If the bright is too bright, you can turn the trim pot on that switch down and it will be nearly the same as the "on" section.

[edwardofhuncote]

^ (so I can find it again...!)

[jerico]

Funny, this thread is years old and I referred back to it a few weeks ago too, and went in and did some adjustments on all of the trim pots again! They make a huge difference!


Happy hols y’all!

[edwardofhuncote]

I haven't adjusted mine yet... but I might just to see. I don't think it's the [bright] setting that I need to tweak. If I understand Mica correctly here, the trimpots only affect the high frequencies that are attenuated in the upper-most position of the switch. I think what I need is a [mellow] switch.


I don't know if what I'm thinking about exists, but imagine that the switch had a fourth position that was between [OFF] and [ON] that was *less bright* than normal. Nuts, huh?