« previous next »
Pages: [1]

Author Topic: Control knobs for Activators  (Read 187 times)

Eric1616

  • Member
  • ***
  • Posts: 158
Control knobs for Activators
« on: May 04, 2019, 06:12:00 PM »
I’m looking to buy gold colored metal control knobs for Alembic Activators.  Any advice as far as what size or specifics?  Thanks.
Logged

David Houck

  • Global Moderator
  • Senior Member
  • ******
  • Posts: 15597
Re: Control knobs for Activators
« Reply #1 on: May 05, 2019, 07:25:13 AM »
There have been two shaft sizes.  Early Epics, Distillates, and Spoilers have a 1/8" shaft size, while all others have a 1/4" shaft size.

If you currently have Hat knobs, you'll need a 1/16" Allen wrench to remove it.

If you currently have Collet knobs, see this page for removal:
http://club.alembic.com/index.php?topic=217.0
Logged

Eric1616

  • Member
  • ***
  • Posts: 158
Re: Control knobs for Activators
« Reply #2 on: May 05, 2019, 07:41:08 AM »
Thanks!
Logged

mica

  • alembic
  • Senior Member
  • *
  • Posts: 10595
Re: Control knobs for Activators
« Reply #3 on: May 05, 2019, 08:15:22 AM »
If the are new Activators, fine. On older ones (before ~1990) are before Clarostat offered the wave washer so you will get static when you turn a metal knob on those.

The post are all 1/4" shaft on the Activators.
Logged

Eric1616

  • Member
  • ***
  • Posts: 158
Re: Control knobs for Activators
« Reply #4 on: May 05, 2019, 08:25:43 AM »
Thanks, yes for the new activators I bought!
Logged
Pages: [1]
« previous next »