Is this wall wart ok for an SF2?

[Picure]

I have an SF2 on the way from Australia. I was looking around the house today and found this wall wart and it seems that it fits the requirements to be an SF2 adaptor except for the 70-100mA part.  This adaptor reads 0.5A input and 1.0A output.

Could fellow club memebers confirm for me if this wall wart is good for an SF2. Thanks!

[adriaan]

The FAQ page for the transformer for the SF-2 says the ouput needs to be at least 200 mA, and 1 A certainly meets that requirement. Voltage is well within the range, and even more importantly the polarity is as required (centre positive is perhaps less common than centre negative).

[Picure]

Cool, I guess this is safe to use then. Thanks!