Author Topic: Musitronics Mutron III power supply question... (Read 117 times)

jx2638 · « **on:** October 08, 2009, 08:49:02 PM »

Is it possible to effectively power a Mutron III with two 9 volt leads running directly from the power supply on my pedalboard to the two internal 9 volt battery connectors...instead of using a 3 pin PS-1 power supply?

tom_z · « **Reply #1 on:** October 08, 2009, 11:37:51 PM »

That's a great question - I would also like to know if anyone has successfully done this. When I acquired my Mutron III it had no power supply and it eats batteries like a pig. I was able to purchase a PS-1 power supply from Lingenberg Sound.

terryc · « **Reply #2 on:** October 09, 2009, 01:14:50 AM »

As long as the milliamp rating matches up to the pedal..I would guess at 300mA for most pedals.

jx2638 · « **Reply #3 on:** October 09, 2009, 07:13:29 AM »

(Message edited by jx2638 on October 09, 2009)

jx2638 · « **Reply #4 on:** October 09, 2009, 07:15:59 AM »

The out jacks on the power supply are all 9 volt x .25A. There are also three 18 volt x .35A out jacks.
Familiar with after market PS-1's (CAE too) but wondered if you could save the $70 by going battery compartment route.