Author Topic: My first Alembic F2B (Read 171 times)

thumbsup · « **on:** February 13, 2011, 08:47:51 AM »

I just got my first F2B pre amp. I am currently scoutin for a QSC PLX amp.
Anyway, plugged the F2B into an old Peavey CS-400 laying around , plugged everything up and....nothing!
Frustration.....Opps....bad instrument cord (Brand New)
I was amazed at the first few notes I played and it only took a few seconds to dail in a tone.
I continued to have a very enjoyable night as did my band mates!
This pre amp is..well..simply amazing..amazing...amazing!
I now wonder if I'd done this 30 years ago if today I may be playing beside Stan, Jocko & Mark!
Did I mention the amazement!
Steve

(Message edited by thumbsup on February 13, 2011)

charles_holmes · « **Reply #1 on:** February 13, 2011, 01:16:38 PM »

Sounds like a match made in the world of Low Frequencies to me Steve! (ah heh heh heh!)
Photos requested please!
Enjoy dialing in the plethera of aurally pleasing frequencies!
Chalie

hieronymous · « **Reply #2 on:** February 13, 2011, 06:15:07 PM »

I love my F-2B so much I have two of them - one on each coast!

slawie · « **Reply #3 on:** February 14, 2011, 01:19:13 PM »

Congratulations Steve,

Wait until you try cascading the signal!

You'll have the rest of your life getting great sounds out of your rig.

slawie

thumbsup · « **Reply #4 on:** February 14, 2011, 04:39:24 PM »

Ahhh...cascading signal?
You may have to cue me in on that!

slawie · « **Reply #5 on:** February 15, 2011, 09:27:44 PM »

Steve,

Plug your bass into channel A input 1 then take the output from the back of the preamp and plug it
into channel B input 1 thake the output from channel 2 into your power amp.
You get a warm rocky distorted sound. Do not worry you cannot damage the F-2B by doing this.

slawie

jack · « **Reply #6 on:** February 16, 2011, 12:20:01 PM »

Can you get an only slightly gritty tone too? Like vintage tube amp, slightly overdriven, as opposed to the fuzz box craziness Heironymous posted somewhere else on this forum? Thanks.

hieronymous · « **Reply #7 on:** February 16, 2011, 01:31:20 PM »

You mean this?

It didn't occur to me to try less, I should have but this is the sound I gravitated towards!

jack · « **Reply #8 on:** February 16, 2011, 01:36:43 PM »

That's the one- serious fuzz!

slawie · « **Reply #9 on:** February 16, 2011, 10:04:56 PM »

Yes you can.

By adjusting the individual channels outputs and tone controls you can
achieve either slight distortion or
hieronymous's fuzzy buzz box extreme zushy sound.

Spend a night going through a variety of settings it was fun for me.
Bonus is that you cannot damage the F-2B!

slawie