Alembic Guitars Club

Alembic products => Alembic Basses & Guitars => Topic started by: iruddle on January 10, 2013, 02:43:10 PM

Title: Series II Bass '78 - low outout from bridge PU
Post by: iruddle on January 10, 2013, 02:43:10 PM

Just managed to get my Series II bass up and running again. I noticed that the output from the bridge pick up is substantially lower than the neck PU. Is there any means of adjustment?

Title: Series II Bass '78 - low outout from bridge PU
Post by: adriaan on January 10, 2013, 03:18:51 PM

You should have four trimpots accessible through four small holes in one of the backplates. The two outer holes are for the output level of the respective pickup, the two inner holes are for adjusting the humcancelling level of the respective pickup.
 
Check  of the FAQ & Must Reads.