Alembic Guitars Club

Alembic products => Owning an Alembic => Troubleshooting => Topic started by: endryq on November 28, 2007, 04:44:13 PM

Title: Questions: F-2B
Post by: endryq on November 28, 2007, 04:44:13 PM

Hey folks!
 
I'm thinking about getting an Alembic F-2B, but there are some questions:
 
There's no D.I. Out. I play alot of live shows and a D.I. Out is a must for me. Is it possible to put a D.I. Box between the F-2B and the power amp? Putting it between Bass and the Preamp is not an option because I want to get the full effect ;-).
 
There is no FX loop, so how can I put some FX in this setup?
 
How do Alembicicans usually handle this?
Would be nice if someone could help me!
Thanks!

Title: Questions: F-2B
Post by: David Houck on November 28, 2007, 04:53:49 PM

In my setup, the effects are after the F-2B, and the DI is after the effects and before the power amp.

Title: Questions: F-2B
Post by: wayne on November 28, 2007, 08:53:53 PM

I don't run effects, but I use the mono out to the power amp, and send the A & B outs through a Radial JDI to the FOH.  Has worked very well so far.  I get post EQ to the FOH and he's happy with the signal clarity and level.
 
Before running this set up, I conversed with Alembic.  There's no problem with running all 3 outs at the same time, you just may notice a drop in volume.  I have not.
 
Based on what I've heard (beware, most of it I don't fully understand), to get the full output from the F2B, be sure that the input impedance of whatever the F2B is feeding is at least 10K ohms.
 
FWIW.....my $.02
 
C-Ya.........wayne