Alembic Guitars Club
Alembic products => Alembic Basses & Guitars => Topic started by: dslapster64 on August 27, 2025, 03:03:02 PM
-
Does anyone have any information on the correct wiring for a three-way Q switch to replace a two wayQ switch?
-
This thread used to have a pdf of the instructions, they may have been lost with the recent website migration. If you call Alembic they can provide you with an instruction sheet.
https://club.alembicguitars.com/index.php?topic=2218
-
Thank you , I’ll give them a call today.
-
I found an instruction sheet I had, here is a photo…
-
Oh my goodness, thank you so much. Blessing to you and all of yours
-
I'm sure there's been some changes since 1997, but something is better than nothing at all. This will certainly give me a start.
-
I'm not sure that's exactly what you're looking for. Aren't you asking about making the boost switch (essentially a 2-way) on your SC Signature into a 3-way? As in, you want more boost? I'm not sure I've seen instructions for that but somebody in here will know if that's doable.
Jimmy J
-
That 2 to 3 way is doable, I had it done on my signature basses some years back. If i remember properly, it came from alembic as pre wired switches and maybe some other bits that i had to swap with the originals and do a bit of soldering.
-
Hey fellas
The swap is for my Spoiler 5 . The switch came by itself with wires connected 👌, but with no installation instructions. The original switch is a 2 way.