Alembic Guitars Club

Alembic products => Alembic Basses & Guitars => Topic started by: Picure on November 04, 2018, 08:37:34 PM

Title: Is this wall wart ok for an SF2?
Post by: Picure on November 04, 2018, 08:37:34 PM

I have an SF2 on the way from Australia. I was looking around the house today and found this wall wart and it seems that it fits the requirements to be an SF2 adaptor except for the 70-100mA part.  This adaptor reads 0.5A input and 1.0A output.

Could fellow club memebers confirm for me if this wall wart is good for an SF2. Thanks!

(https://dl.dropboxusercontent.com/s/uxy1hvmhdlm8ale/Photo%202018-11-5%2C%2012%2031%2027%20PM.jpg?dl=0)

Title: Re: Is this wall wart ok for an SF2?
Post by: adriaan on November 04, 2018, 11:39:49 PM

The FAQ page for the transformer for the SF-2 (http://"http://club.alembic.com/index.php?topic=264.msg1080#new) says the ouput needs to be at least 200 mA, and 1 A certainly meets that requirement. Voltage is well within the range, and even more importantly the polarity is as required (centre positive is perhaps less common than centre negative).

Title: Re: Is this wall wart ok for an SF2?
Post by: Picure on November 05, 2018, 01:50:56 AM

Cool, I guess this is safe to use then. Thanks!